Print Profile(2)
PETG 0.2mm layer, 2 walls, 15% infill
Designer
1.1 h
1 plate
PLA 0.2mm layer, 2 walls, 15% infill
Designer
1 h
1 plate
Open in Bambu Studio
Boost
22
44
18
0
146
87
Released
Comment & Rating (18)
All
Print Profile
PLA 0.2mm layer, 2 walls, 15% infill
broke when removing it from build plate
0
Reply
Print Profile
PETG 0.2mm layer, 2 walls, 15% infill
I love the print
(Edited)0
Reply
Print Profile
PLA 0.2mm layer, 2 walls, 15% infill
Had to fight quite a bit to get good adhesion
0
Reply
Print Profile
PLA 0.2mm layer, 2 walls, 15% infill
could never get this to print no matter orientation/ slicer options I ran through..even extreme zhop.to try to prevent it from hitting already printed parts
0
Reply
Print Profile
PLA 0.2mm layer, 2 walls, 15% infill
Bed Adhesion Issue:tried printing 4 times with 3 different plates model looks like it would be great if it could finish printing
1
Reply
same ,even went to town in another dryer down to 5% left and still can't get it to print .
0
Reply
Print Profile
PLA 0.2mm layer, 2 walls, 15% infill
Other Issues:Teile lösen sich beim Druck. Spaghetti-Bildung
The designer has replied
0
Reply
3d spray, hair spray
0
Reply
Print Profile
PLA 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
PETG 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
PLA 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
PLA 0.2mm layer, 2 walls, 15% infill
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld