WHAT IS IT?

This is a scoop holder for the Frigidaire Countertop Ice Maker model EFIC117. It doesn't come with one in the box, so this is my solution. 

Uses only approximately 3 grams of filament and prints in under 30 minutes depending on your printer and settings!

ADDITIONAL HARDWARE NEEDED

• Double-sided tape

MY PRINT SETTINGS

You can probably slice and print this in any way you please. If you're using a fast printer, it'll probably take longer to heat up and level the bed than it will to print.

INSTRUCTIONS

1. Slice the STL with your preferred slicer.
2. Print the scooper holder.
3. Use double-sided tape to stick the ice scoop to your ice maker in your desired spot. An example is shown in the cover photo for this model.