Spool Wight GST3D and Bambu Lab
Copyright Claim
Spool Wight GST3D and Bambu Lab
Boost
7
15
8
Print Profile(1)
0.28mm layer, 4 walls, 15% infill
Designer
1.3 h
1 plate
Boost
7
15
8
0
48
41
Released
Description
i designed a real simple gut effective spool-wight for my GST3D Spools.
i desguned it for useing it in my BambuLab AMS.
it is desinged to not fall out without opening it.
it works also with BambuLab Spools,
there it can through the center-hole ,
but also working great.
there is space for 5AA and 1 AAA Batery ,
or whatever you wanna fill inside.
also on my Printables:
RainerBavaria | Printables.com
Comment & Rating (8)
All
Print Profile
0.28mm layer, 4 walls, 15% infill
they print nice. Little bit of filament left in the slot. I'm going to have to adjust the diameter and length for the new IIID Max filament spools. but they are working great so far. thank you.
0
Reply
Print Profile
0.28mm layer, 4 walls, 15% infill
schnell zu drucken
(Edited)
0
Reply
Print Profile
0.28mm layer, 4 walls, 15% infill
Passt genau wofür es gedacht ist.
0
Reply
Just printet this and it came out pretty nice. Only thing is that the "outer tube" is a bit small compared to the hole in the spool.
I dunno if there is lot of deviation on GST spools but if they are pretty consistent it would be cool with a slight "press fit" OD-0.2mm ish :-)
0
Reply
Print Profile
0.28mm layer, 4 walls, 15% infill
0
Reply
Print Profile
0.28mm layer, 4 walls, 15% infill
0
Reply
Print Profile
0.28mm layer, 4 walls, 15% infill
0
Reply
Print Profile
0.28mm layer, 4 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld