Love by Never Disarm

Never Disarm

Household>Decor

IP Report

Print Profile(3)

All

P1P

P1S

X1 Carbon

X1E

A1 mini

0.2mm layer, 2 walls, 15% infill (New profile with new Pin)

Designer

6.2 h

1 plate

4.8(83)

Tighter hole on base for better fit

6.3 h

1 plate

4.8(20)

70% mini friendly 0.2mm layer, 2 walls, 15% infill

3.9 h

1 plate

4.8(16)

Open in Bambu Studio

Boost

675

1087

144

1.5 k

775

Released

Description

Happy Valentine Day

Comment & Rating (144)

@xtraspin

Print Profile

0.2mm layer, 2 walls, 15% infill (New profile with new Pin)

Cute model. the stand hole is too large or the mounting peg is too small this allows the model to rock left and right. wish the fit was tighter and the model would stand straight up.

(Edited)

@3damericana

had the same issue but other than that, it was awesome

@F_K3NT_D

Replying to @3damericana :

I added a print profile that corrects this issue

@user_2790672644

Boosted

Replying to @F_K3NT_D :

where it is?

@2ndstoryprinter

I loved this heart from the moment I saw it. I gave it to my wife today !!

The designer has replied

@NeverDisarm

Thanks! and nice print

(Edited)

@F_K3NT_D

I added a profile with a tighter hole on the base to better hold the heart. All I did was added a block in Bambu Studio and resized it so that it sits within the original part and cannot be seen. Carefully apply a little force to push the heart into the base, no glue required.

The designer has replied

@NeverDisarm

I advise you to check your printer settings because there is no gap in the drawing; so if it is too wide for you there is some problem in your settings

@F_K3NT_D

Replying to @NeverDisarm :

I'm not the only one experiencing the issue. The heart fits in the hole but it's way to loose causing it to lean. I tightened the hole with a block in Bambu Studio so that when the heart is put on the base it basically becomes one piece.