Phone Stand
Copyright Claim
Phone Stand
Boost
34
61
49
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
1.5 h
1 plate
Boost
34
61
49
1
397
443
Released
Description
I needed a phone stand that would sit lower and not block my monitor. While still being able to charge the phone and use it for face tracking in vtube studio.
Comment & Rating (49)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
Well made, supports came off easily and without leaving any residue. Perhaps I would make the L-shaped base where the smartphone rests 1.5mm wider, my phone doesn't fit with the entire cover, but it is still stable.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
I printed four of these and they are all excellent! thank you so much for this great design.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Amazing print in petg!
0
Reply
Printed great but I make it a bit bigger for my Iphone 14 Pro. Holding strong.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Printed great using PETG
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
A good one, but keep in mind that this stand should be put on a rough surface (on bed won’t work)
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
top 😁 this is exactly what I needed
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
(Edited)
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Spouse approved.
(Edited)0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld