Simple Vase Mode
Copyright Claim
Simple Vase Mode
Boost
16
31
24
Print Profile(1)
0.2mm layer, 1 walls, 0% infill
Designer
40 min
1 plate
Boost
16
31
24
0
172
131
Released
Description
Simple vase
Quick, simple test for vase mode.
Quite fragile: Fine as an ornament but if you squeeze too hard it will fall apart!
Standard PLA. Default settings in Bambu Studio + vase mode
Comment & Rating (24)
All
Print Profile
0.2mm layer, 1 walls, 0% infill
Good test that printed nicely.
(Edited)
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
very lovely vase
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
came out great
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
可以正常打印 结果OK
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
sxa
Strength Issue
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
Cute but not waterproof
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
This was just a successful test and it did well
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
Like it says on the box: a simple vase mode test print.
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
good for testing
0
Reply
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld