P1S
Just wonderful!
Printed with suggested settings (0.2/15%/3walls) with Bambu Orange PLA = Super Smooth , Super fit!
NOTE: the seam in the front middle is Not Visible with the eye - the camera picked up on for some reason.
great fit. i added some 3M heat resistant tape to the inside and attached a light strip with no soldering needed. Wish there was a glass lift that was made for this too, would be a good accessory.
Turned out great and looks sleek. I used a hammer to bang the pieces together - tight fit but it makes it very sturdy. I am printing a second one as I type this review and have shared the link with my dad and highly recommended it to him. I printed it in PETG Skin colour.
Thanks so much. Well done! PS I also gave you a Boost token 🤓