T-Rex Kit Card
Remixed by
Copyright Claim
T-Rex Kit Card
Remixed by
Boost
133
339
40
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
1.2 h
1 plate
0.12mm layer, 2 walls, 15% infill
Designer
1.6 h
1 plate
Open in Bambu Studio
Boost
133
339
40
1
263
236
Released
Comment & Rating (40)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
good Design, but the parts are hard to remove by hand and the both holes on the bottom (stand) are not big enough to hold the dino + sign (needed to adjust them a bit with a scissor)
(Edited)
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
Great print. Printed well. Only issues is the tolerance on the pegs going into the base. The pegs are just a bit too large to fit. I had to shave down both pegs to get it to fit together with extra force to get them in.
And the tail connection tolerance is just a tad too loose. will need to glue it to get it to stay. I accidentally knocked the completed model over and the tail fell off just from that.
Every other tolerance was perfect. Just tight enough that you need to force it a littlle.
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
Printed perfect (esun pla+ bone) :)
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
printed well
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
Super Design und problemloser Druck. meine Tochter hatte viel Spaß beim Zusammenbau.
Danke für die tolle Arbeit.
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
Turned out really cute.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
super cool printed grate on my A1
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
only complaint is the pieces have to be glued or they won't stay together. otherwise great job. looks great once assembled and printed perfectly
1
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
Printed well :)
0
Reply
printed well
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld