Support the designer:

• Donate Bitcoin here: bc1q9mhh7l53mmlnqqmazdnr6gele0smrzkunclfvj
• Donate Ethereum here: 0x36CA6EEF3700ff18858f195706C5E3A9d6458241

This design is a simple latch point that you can clamp with 2 x M3 screws and heat inserts to other things.

Example:

I designed it so that I could add two hook point to my snowboard carry bag so that I could clip on shoulder straps and carry it like a backpack.

Bill of materials:

• M3 heat inserts (OD 4.2 mm and 10mm length). (2 needed per hook clamp set: part 1 + 2)
• M3 screws (12mm length). (2 needed per hook clamp set: part 1 + 2)

Print instructions:

• print hook point part (part 1) with hook point up. This is to print the holes well sized for the heat inserts. Another orientation might change the size of the holes.
• print clamp part (part 2) on its side.
• Use an outer brim

Build instructions:

• inset the heat inserts with a solder iron.
• insert both parts around object to be clamped (preferably fabric / rope)
• screw in both screws at the same time.