Just another vented riser. Wanted to try my design skills and wanted a better way to mount my X-Touch screen, so I designed my own vented riser for the touch screen and a bit of storage for frequently used small tools. Tolerances are pretty tight, so make sure your printer is dialed in with good flow rate. I don't use material that requires high heat, but I designed in panels that can be slipped in each wall to block the vents. The inner top is angled and wide enough to mount LED lights. I recommend printing this in PETG and leaving the supports I have in the print. Yes some of it will print without the supports, but it fits much better with the supports added and all supports remove very easily. I also have a brim, but that is optional. Requires 4 M3 x 6mm screws to mount the screen. All plated are named for what they are and how many needed if multiples are needed.