Search models, users, collections, and posts
Mighty & Mighty+ Stand (Charging Compatible)
Print Profile(1)
Mighty Base, all versions - 0.2mm layer, 3 walls, 15% infill
Designer
2.1 h
3 plates
Open in Bambu Studio
Boost
65
193
91
31
503
447
Released
Description
Tired of your Mighty tipping over? This slide-on base gives it the stable foundation it should have had from the factory, keeping your device upright and ready to use.
- Charge While Standing: Precision cutout at the bottom means you never have to remove the stand to plug in.
- Stays Attached: A snug friction fit that stays on when you pick the device up, but slides off easily if needed.
- WPA Ready: Provides essential stability for anyone using heavy glass water pipe adapters.
Printing & Fitment:
- No supports required.
- Walls: I suggest 3+ walls for a solid, high-quality feel.
- Fitment Note: If the fit feels too tight on your specific printer or filament, I suggest scaling the model up to 101% in your slicer.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (91)