strong cable wall bracket holder by porlock

porlock

Tools>Organizers

Print Profile(1)

All

X1E

P1S

P1P

X1 Carbon

0.2mm layer, 2 walls, 15% infill

Designer

1.6 h

1 plate

4.0(2)

Open in Bambu Studio

Boost

Released

Description

One printed from PLA clip was able to hold 3 KG of load.

Make routing cables easier, can be printed in multiple colors to match your wall or cable.

Comment & Rating (4)

@user_3833407229

Good model too bad i have same issues as the other commenters that they kept getting knocked off

@Tawpie

I couldn't get a successful print on a mini, unable to provide enough cooling to keep the overhangs from curling up and getting knocked off the build plate.

@brownie2010

Print Profile

0.2mm layer, 2 walls, 15% infill

@Tawpie

Print Profile

0.2mm layer, 2 walls, 15% infill

Other Issues:It's not so much of an adhesion issue, but all of the parts I tried to print got knocked off the bed at basically the same place. I suspect cooling as the primary culprit, as it was trying to close one of the tops of the cable 'holes' there must have been some curling that lead to what basically was a collision with the model. It was a little funny to watch—one by one they got popped off. I didn't get any to complete and tried about 20 objects on 3 different runs.

No more