Multiboard push-fit-snap 25x75x50 sloped front bins
Remixed by
Copyright Claim
Multiboard push-fit-snap 25x75x50 sloped front bins
Remixed by
Boost
4
17
4
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.6 h
2 plates
Open in Bambu Studio
Boost
4
17
4
0
33
11
Released
Description
A very tight fitting snap-in bin for your Multiboard's push-fit (hex shaped) connectors. I made this quite snug so the first few times you go to take it out, you do have to wiggle it quite a bit. After a few insertions and removals, it gets a bit easier but still holds quite well.
There are 2 models: one is ~75mm wide, and the other is split in two (so you have 2 bins each ~37mm wide)
The bottom of the bin is filleted to make it easier to get little things out.
The push-fit-snap connector is based on https://thangs.com/designer/Keep%20Making/3d-model/Push-Fits%20-%20STL%20Multiboard%20Remixing%20Files-994668 to which I added an interference snap to the top, left and right sides.
Comment & Rating (4)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Perfecto 👌
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
works great, i printed a few of these. snug push fit but snug is what you want
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld