Teddy Bear
Copyright Claim
Teddy Bear
Boost
28
33
13
Print Profile(1)
0.2mm layer, 2 walls, 5% infill
Designer
2.7 h
1 plate
Open in Bambu Studio
Boost
28
33
13
0
131
71
Released
Description
Beautiful bear for this valentine season, you can place fuzzy skin for another texture.
Comment & Rating (13)
All
Lovely Bear Print, it came out very well & Fuzzy after 13H45M roughly.
Printed without supports as it suggests using Bambu Labs PLA. No issues.
Coloured up to how I wanted him to look as I didnt have bear browns but I did use my Bambu Labs AMS to colour him, Red,yellow,blue,silk gold & beige, hense the print time, set it up last night to print through the night & while I went to work today & all finished by lunch time.
I will print him again once I purchase brown colours that will suite him better. 5 * print
Thx to SamActivity for sharing :)
0
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill
printed well on my a1 mini
0
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld