E61 Tamping station
Copyright Claim
E61 Tamping station
Boost
17
35
5
Print Profile(1)
0.2mm layer, 6 walls, 20% infill
Designer
6.8 h
1 plate
Boost
17
35
5
1
81
24
Released
Description
E61 tamping station. Compatible with most if not all E61 portafilters. It has 2 58mm holes for your tamper or distributor and a slot for . I put my dosing ring under the tamping area.
The tamp station is designed to fit bottomless portafilter or single/double spout.
I printed mine in PETG but PLA should work fine.
It takes around 6hr51m to print with ironing on top surface.
Comment & Rating (5)
All
Print Profile
0.2mm layer, 6 walls, 20% infill
(Edited)
Other Issues:this is a great model and substantially printed OK, but the attempt to iron the surface in this profile (with Bambu PETG) left parts rough and messy as pictured. I will try a fine sandpaper to see if I can rectify!
2
Reply
Does this fit 58,4mm tamper and distributor? Or is it only for 58mm strict?
The designer has replied
0
Reply
basket size is irrelevant. the hole is 74mm so you can measure your portafilter to see if it fits
0
Reply
Is it possible to print this for a 51mm portafilter
0
Reply
Print Profile
0.2mm layer, 6 walls, 20% infill
1
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld