Insulin Case for 2x 10ml bottles
Remixed by
Copyright Claim
Insulin Case for 2x 10ml bottles
Remixed by
Boost
12
31
5
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
56 min
1 plate
Open in Bambu Studio
Boost
12
31
5
2
33
42
Released
Description
Remixed version of JoerT 's Insulin Holder to accommodate 6x3 magnets.
These might push fit depending on calibration, however, it's usually easier to put a dab of superglue under them, just watch out for the polarity.
There are multiple bodies in the STEP and STL files. Split them up before printing.
I included separate TOP and BOTTOM STL files for your convenience.
Comment & Rating (5)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Fantastic fit and easy assembly with the magnets. Much thanks!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
a perfekt life saviour! i use it for the novorapid bottles
0
Reply
Fantastic, printing this for my partner for when we go camping. Much thanks!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
prints great and perfectly sized
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld