Cyborg Girl

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

I wanted to test the TD and 'blendabilty' of my white filament and see the full layering effect that Hueforge was made for. This print absolutely did not disappoint!

Filaments Used:

• PLA Siddament Black Transmission Distance: 0.2
• PLA+ Sunlu Grey Transmission Distance: 1.4
• PLA Overture Light Grey Transmission Distance: 1.6
• PLA Sunlu Lilac Transmission Distance: 6.6
• PLA META Sunlu White Transmission Distance: 9.6

Swap Instructions:

• Start with Black
• At layer #12 (1.04mm) swap to Grey
• At layer #15 (1.28mm) swap to Light Grey
• At layer #17 (1.44mm) swap to Lilac
• At layer #19 (1.6mm) swap to White for the rest.

Your filament settings and mine may differ in TD, so best to adjust yours according to your known TD filaments.