Hyte Y60 triple fan bracket by kataya

kataya

Hobby & DIY>Other Hobby & DIY

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 3 walls, 15% infill

Designer

1.3 h

2 plates

4.3(3)

Open in Bambu Studio

Boost

Released

Description

A bracket to place 3 120mm fans in the upright position in the Hyte y60 case.

Just screw the bracket on your fans and slide into place with the hooks in the wider slots.

I had to pry one of the hooks into the slot but it holds the fans very well.

If anyone has ideas on how to get this into 1 build plate please let me know

Comment & Rating (6)

@06andrewbe

Print Profile

0.2mm layer, 3 walls, 15% infill

I'm a fan

@user_347270674

This design worked brilliantly. I had to split the first model into two, to print three individual brackets because my Ender 3 doesn't have enough build area to print them as a whole. I also made the brackets thicker for better structural integrity. I drilled some holes to zip tie the brackets together, and to the case. I now have 3 NZXT F120 Core fans mounted on my side panel of my Hyte Y60. Thanks for the model!

@jmp7624

Print Profile

0.2mm layer, 3 walls, 15% infill

I'm only giving this 3 stars because the wholes didnt line up with my 120mm fans. I had to cut the bracket down the middle and drill out new wholes to get it working. I don't understand why when 120mm fans should have the same screw placements since they are standard but it was off a few mm. I used my P1S and its dialed in so I don't know what the issue was. If the screws lined up, this would have easily been a 5 star review. I love how it locks in place.

The designer has replied

@stanpeeren58

Thanks for the reply, might have been a mistake on my part since this is the first design i made i'll have another look soon to improve! glad to hear you like it