Paper towel Voronoi design
Copyright Claim
Paper towel Voronoi design
Boost
6
17
9
Print Profile(2)
0.12mm layer, 2 walls, 15% infill
Designer
7.6 h
1 plate
0.12mm layer, 2 walls, 15% infill
Designer
61.3 h
1 plate
Boost
6
17
9
0
25
13
Released
Description
Introducing a table-top paper towel holder featuring an intricate Voronoi pattern, designed for multicolor printing. This holder is both stylish and functional, adding a unique touch to your kitchen or dining area.
Profile details :
- No support needed
- 0.12mm layer height Recommended for superior overhang quality
- Gyroid infill
You can reduce the printing time by adjusting the layer height but you risque bad overhang above 0.16mm
Important Tip:
- It's possible to decrease print time by increasing the layer height, be cautious. Overhang quality may deteriorate with layer heights above 0.16mm.
- For optimal fit, if you're using the standard STL or 3MF files without pre-configured settings, it's advisable to scale down the X and Y dimensions to 98%
Enjoy
Comment & Rating (9)
All
nice model but I just had problems while printing it fails completely at nearly the same point
The designer has replied
0
Reply
Hi, what kind of printing fail are you experiencing and what printer do you use ?
0
Reply
Is use the a1
there always some broken branches
and always like halfway through a big layer shift
0
Reply
in the second print I printed the base with a 50% infill for more stability
I also use the standard settings for high quality at 0.12 layer high expect ich reduced the acceleration by half
0
Reply
printed great!
1
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
works good added a little weight to the bottom of the holder to prevent tipping.
1
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld