The eye of the Dragon

The original artwork was created by me using an online text-to-image AI creator Dezgo and JuggernautXL. The eye itself was removed from the background and the two pieces were colored separately in HueForge. The pieces are printed separately and then put together with simple two-sided tape.

The artwork is 15 cm x 15 cm.

The design is based on Bambu lab basic filaments (black, white, red, yellow) but I used other filaments with approximately the same colors (Creality PLA+ black, Creality PLA+ white, eSun PLA+ fire engine red, Creality CR-PLA yellow).

Remember to print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm.

Plate 1: the skin

• uses two colors: black and white
• start with black
• at layer #4, swap to white for the rest

Plate 2: the eye

• uses four colors: black, red, yellow and white
• start with black
• at layer #7, swap to red
• at layer #14, swap to yellow
• at layer #22, swap to white for the rest