Hi, thank you for your mount, it's great.
But when printing I got a smaller hole, namely 19mm, I was printing ABS, can you tell me how to change it to 20mm ?
Thank you very much
You're probably right, it's ABS that gives shrinkage, it's just that I need to print in this particular color :)))
I honestly tried to enlarge the holes on tinkercad, but I can only enlarge the whole model, but the holes don't work.
Can you help me to enlarge only the holes by 2mm please :))
Or maybe try scaling just by 1,5-2% ?
Nice print, this was exactly what I needed. The rod I bought has a smaller diameter so I took advantage of it and created a little cap for the rod. Here's the cap link if anyone's interested: https://makerworld.com/en/models/426585
Printed extremely well, tolerances were tight and held secure, Originally i printed 2 wound up getting 4' dowels and after about 7 KG of filament the dowels were deflecting and would likely break or spread enough to allow collapse, Re printed in different filament (Both Basic Pla) able to slide thru to middle supporting the dowels and adding another point to secure to wall confident this will hold 16 full rolls without issue.