I created a dishwand holder. It is meant to sit on the edge of the sink so that water from the dishwand will fall back into the sink. It is design to hold all different kinds of dishwands. It designed so that dishwand will never be sitting in water and everything will drain of of it. Additional, I have added small diamond shaped features on the surface that the dishwand sits. This help whatever dishwand that is put it for moving/sliding around.

In the print profile I have uploaded. There are 2 sheets. Each sheet has the same model. Sheet 1, the model prints from the back forward, its the fastest print time with the least amount of material and no supports needed. I have printed a few of them and every once in a while a edge lifts up. So I added Sheet 2, it prints from bottom to top, it takes longer, more material and has supports but the model wont lift. I just wanted to give options for you.

Dimension: 165mm (height) x 100mm (width) x 80mm (depth)

Printer: X1C

Filament: NuMaker PLA+

.20 Standard Bambu profile

Please leave a review (good or bad). Let me know what you liked or something you would like changed.