Makerchip Launcher

I would like to Thank the Original designer jindouyun . He was kind enough to let me have the source files so I could remix this to work with makerchips. 

This is a makerchip launcher and I have spent a ton of time rebuilding the front and tuning the spring to help get a nice launch. 

I have also replaced the pin that holds in the top with 1.75mm filament.  just place a spare piece of filament in the hole and chop off the other side. 

It holds up to 6 chips and shoot them as fast as you can pull the switch. 

If it gets jammed just push it back and launch again. 

i have added some alternative springs if you are having issues launching. 

All you makers have fun Launching your Chips. 

here is the Assembly Video please note I made the hole smaller for filament not a pin like the video.