HueForge version of the famous Raising the Flag on Iwo Jima photo.
This is part of my HueForge collection using polymaker filaments. Although it was designed with polymaker filaments, others can also be used.
Print Settings
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
PLA PolyTerra Charcoal Black Transmission Distance: 0.3
PLA PolyTerra Fossil Grey Transmission Distance: 0.3
PLA PolyTerra Cotton White Transmission Distance: 2.5
Swap Instructions:
Start with Charcoal Black
At layer #10 (0.88mm) swap to Fossil Grey
At layer #13 (1.12mm) swap to Cotton White for the rest.
The following filaments were used in the pictures above: