I print a lot of very small parts and was concerned that when curing them in the curing station they were only getting UV light from above. This plinth raises the turntable by 68mm thus allowing light to shine on the parts from below through the clear turntable.

You can use it as-is, or if you want to secure it magnetically like the original plate there are slots for 4 x 15x2mm magnetic discs - https://www.amazon.co.uk/Magnet-Expert-15mm-thick-Neodymium/dp/B00TACL9QI/ref=sr_1_2?dchild=1&keywords=15x2mm+magnet&qid=1615479875&sr=8-2

You will need 2 x M3x5mm fastners to complete the plinth.