This is an attempt to add more colours to my designs, still tweaking and experimenting but i liked this one so decided to share.

Ignore the hole in the centre of the design, it is not there on the uploaded design

Looking forward to see your makes and colour experiments on this one :)

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:

• PLA Overture Black
• PLA PolyTerra Charcoal Black
• PLA Overture Cement Gray
• PLA+ Sunlu Gray
• PLA+ Esun Orange
• PLA+ Sunlu Pure Yellow
• PLA Overture Light Yellow

Swap Instructions:

• Start with Black
• At layer #6 (0.56mm) swap to Charcoal Black
• At layer #8 (0.72mm) swap to Cement Gray
• At layer #9 (0.8mm) swap to Gray
• At layer #11 (0.96mm) swap to Orange
• At layer #14 (1.2mm) swap to Pure Yellow
• At layer #20 (1.68mm) swap to Light Yellow for the rest.