hardware required:
assembly:
The 4 m3x8 screws go in the bottoms of the handles with the spacer with the angled side pointing towards the base of the handle, the m3x6 screws go into the blade on a side of your choice. You need 4 shims, one in the top and bottom of each side of the blade. Press the nuts into the handles and screw the 12mm screw through both handles and the blade into the nut (The dots on the inside of the handles must face the inside when the knife is open). You can adjust the tension on the 12mm screws to change how tight the hinge is, it will take a bit of tuning to get it right.
print settings:
notes for printing:
the print profile included has a pause so you can change filament for the hexagons on top of the handles
if you print without the print profile you will need to mirror the top and bottom handles so you have 4, 1 top 1 bottom and 1 top mirrored and 1 bottom mirrored