Joy-Con Steering Wheel by bhling

bhling

Hobby & DIY>Electronics

Print Profile(6)

All

P1S

P1P

X1 Carbon

X1E

A1 mini

faster print: PLA Only, 0.16mm layer, tree (auto) organic

Designer

5 h

1 plate

4.5(38)

PLA only, 0.1mm layer, tree (auto) organic

Designer

6.9 h

1 plate

4.8(10)

PLA with PETG support, 0.1mm layer, normal (auto) support

Designer

7.5 h

1 plate

5.0(3)

A1 Mini Profile: PLA w PETG Support

Designer

8.9 h

1 plate

4.5(2)

Click to see more

Open in Bambu Studio

Boost

190

434

800

522

Released

Description

This is a Joy-Con Steering Wheel perfect for Mario Kart – the ultimate accessory to enhance your racing experience! Designed with precision and comfort in mind, this steering wheel attachment transforms your Joy-Con controllers to simulate a real steering wheel, bringing a new level of immersion to your Mario Kart gameplay.

Easy to install, simply press the Joy-Con into the wheel, and when you're done you can easily remove it by pushing it out from the other side. The secure fit ensures that your controller stays in place throughout your intense racing adventures. The responsive buttons and accurate motion controls of the Joy-Con is seamlessly integrated into the steering wheel, allowing you to execute drifts, boosts, and jumps with ease.

For better quality, I used PLA with PETG as the support interface, but it can be printed using only PLA. I hope you enjoy!

Comment & Rating (59)

@tuny

Print Profile

faster print: PLA Only, 0.16mm layer, tree (auto) organic

Supports didn’t hold the bottom layer of the circle well, same issue happened across 4 separate prints. overall, printed well though.

(Edited)

@oxobfe

Print Profile

PLA with PETG support, 0.1mm layer, normal (auto) support

X1C - BambuLab Cobalt Blue Metallic PLA + Sunlu Clear PETG. Had door cracked open during print. Excellent design with well placed supports. My fault for choosing a silk PLA for a functional print. The PETG support interface made a good bond with the supports while eventually releasing off the print cleanly but I’d advise removing it slower than I did.

@mvachon8706

Boosted

Print Profile

faster print: PLA Only, 0.16mm layer, tree (auto) organic

print great!

@Terr0r_Arie

Boosted

Print Profile

PLA only, 0.1mm layer, tree (auto) organic

Had some trouble with warping, so I added a brim and had a lot of strings so I turned up nozzle temp. Overall nice print and happy with the results.

@AdamSid

Print Profile

faster print: PLA Only, 0.16mm layer, tree (auto) organic

we have all family set already:) 4 wheels)

@Szynthia

supports were a bit fiddly but it works nicely

@Scoop20

Print Profile

faster print: PLA Only, 0.16mm layer, tree (auto) organic

It had weird holes as seen in the picture below. Holds the remote in place nice though.

@Tav3n

Print Profile

faster print: PLA Only, 0.16mm layer, tree (auto) organic

Support issues. The print itself is perfect but when printed direct the supports are missing in the lowest peak of the curve, definitely recommend opening in your slicer and tweaking support settings before orinting