Iron Man by Almitoen

Almitoen

Generative 3D Model>Hueforge & Lithophane

GIF

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.08mm layer, 2 walls, 100% infill

Designer

5.7 h

1 plate

5.0(6)

Boost

Released

Description

Here's an artistic image of Iron Man aka Tony Stark. Super hero marvel !

Filaments Used:
PLA+ Ender Creality Black
PLA+ Ender Creality Red
PLA+ Esun Yellow
PLA CR-Creality White

For more artworks follow the link : https://makerworld.com/en/u/4155266308

good print !

Comment & Rating (16)

@Crome

Print Profile

0.08mm layer, 2 walls, 100% infill

Excellent Print! My son & I really like it a lot, probably the cleanest looking print out of the dozen or so we've done so far. Thank You!

The designer has replied

@Almitoen

Glad you like it! Very good rendering with your colors.

@Crome

Thanks! I really like it too, I used pla red, jade white, silk gold and iron gray metallic

@kisuijx

This hueforge is mind blowing ! My only regret is that most of the visible black part is very thin (just one layer). It makes it very fragile and where there is a bit of under extrusion, I can see through. A base with 3 full layers of black would make it sturdier and even better. If it is updated, I would gladly print it again ! Thanks for sharing :)

The designer has replied

@Almitoen

Hi, thanks for your feedback. Is the height of the first layer set to 0.2? Or would you have changed the file size? In my test the black is not transparent (see picture).

@kisuijx

Replying to @Almitoen :

I used the print profile provided (initial layer at 0.2), it was resized at 78.12% by default. So I didn't change anything, shoud I have set 100% on Z ? 0.2mm is It's only transparent with a powerful light behind. When I look at it is fine, but it feels a bit fragile with only one layer :)