Umbrella ID Card Holder
Remixed by
Copyright Claim
Umbrella ID Card Holder
Remixed by
Boost
19
32
7
Print Profile(1)
Choose Design from Plate
Designer
3.1 h
2 plates
Open in Bambu Studio
Boost
19
32
7
2
74
62
Released
Description
Changes to original Model:
- rescaled
- character now printing correctly
- recoloring
- alternative support
- additional design
The triangle effect is done by an alternate so called PEO print plate from the big A marketplaces.
I had some print iterations until all was fixed.
If you like it, please rate my print profile.
Comment & Rating (7)
All
Print Profile
Choose Design from Plate
Prints just like the pictures. A tad bit small for a standard sized ID, but that was easily fixed in BambuStudio
The designer has replied
0
Reply
Thank you very much for sharing your picture and feedback. I will make it a bit bigger
(Edited)2
Reply
Print Profile
Choose Design from Plate
Nice remix model. I had to change the size to 100.4% for a better fit. With this "change", it still tight, but makes it easier to add or remove the ID card.
0
Reply
Print Profile
Choose Design from Plate
leider hat es nicht gepasst trotzdem gutes model
0
Reply
Print Profile
Choose Design from Plate
Standard cards do not fit inside
0
Reply
Print Profile
Choose Design from Plate
0
Reply
Print Profile
Choose Design from Plate
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld