Hello everyone.

Only support is needed for middle piece. It has a hole that needs to be printed into.

Those supports are relatively easy to remove.

This is a model I created that allows funkos to be displayed in a two story fashion. I was asked to make a model to fit the criteria of a shelf. The customer could not stack the funkos because there was not enough room for them both to fit (height wise).

So I took it upon myself to model and print the shelf. Its a pretty simple model and needs not much description.

Use it for all types of things ! The tolerance on the cuts should allow you to easily slide them into each other when assembling.

Use glue for secure fit or dont for easy disassembly.

Let me know any feedback or advice! Thanks