Digital Mitutoyo 6in Model CD-6-ASX Slim Magnetic Case by JGourley86

JGourley86

Tools>Measure Tools

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 10% infill, textured PEI plate

Designer

1.8 h

1 plate

4.6(14)

Open in Bambu Studio

Boost

164

190

Released

Description

Slim magnetic case for Digital Mitutoyo 6" Caliper Model CD-6-ASX. Slim case provides protection while retaining the caliper in the case with a magnet.

Print in single piece and press/glue in McMaster Carr magnet

https://www.mcmaster.com/5862K418/

Comment & Rating (25)

@magalex28

Print Profile

0.2mm layer, 2 walls, 10% infill, textured PEI plate

I printed this model for luck, since I have another caliper model for which I have been looking for a printable case for a long time, but none of the models I liked were suitable. Yours fits! I'm so happy :) Thank you very much! My caliper model is Vogel 202040-3. The only thing is that the thumb wheel rests 1.5-2 millimeters earlier. Maybe I'll make remix later, but at the moment I'm happy anyway :) Special thanks for the STEP file!

(Edited)

The designer has replied

@JGourley86

@magalex28 Great to hear. Thank you for the feedback.

@msa1906

Print Profile

0.2mm layer, 2 walls, 10% infill, textured PEI plate

fit perfect with my tool.

(Edited)

@robertogg1697

can you make a 8" version?

The designer has replied

@JGourley86

@robertogg1697 Yepp. Can you provide the model number so I can verify features? Are you planning to print this on a Bambu Printer? The overall length of the new part is 11 3/8", so you would need to print on an angle or print in pieces. Let me know what you are looking for.

(Edited)

@robertogg1697

Replying to @JGourley86 :

going to use it for a pair of Mitutoyo 8" digital calipers (Mitutoyo 500-197-30 to be specific) and yeah, I am going to print it on my A1

@JGourley86

Replying to @robertogg1697 :

@robertogg1697 file sent to your PM.

@matteo346

Print Profile

0.2mm layer, 2 walls, 10% infill, textured PEI plate

The designer has replied

@JGourley86

@matteo346 did you have problems printing?

@a5453611

I really like the caliper case. It would be great to have access to the CAD file to make small adjustments. My friend at work wanted me to make one for him with some small modifications but the one that I use is fine.

The designer has replied

@JGourley86

The STEP is included in the raw model files. What file format are you looking for and what CAD program are you using?

@Lipoma

Print Profile

0.2mm layer, 2 walls, 10% infill, textured PEI plate

thanks

@Nouyoter

Print Profile

0.2mm layer, 2 walls, 10% infill, textured PEI plate

Support Issue

The designer has replied

@JGourley86

@Nouyoter was there a problem with the print?

@Nouyoter

Replying to @JGourley86 :

Yeah, I don't know if it was the profile or bad bed adhesion but a little after the point where it branches off for the tip it fell off the plate. Still good but it's missing the top and I had to cancel it