This Jeep Wrangler Door Handle Inserts requires adhesive tape to attach, NO DRILLING REQUIRED.

You can warm insert in hot water or use heat gun to form to the slight curve of door handle. I used a small torch for a few seconds, doesn’t require much to conform to your OEM handles curve.
I used 3M VHB Tape, in 4-5 spots to attach.

MODELS:

• Jeep Handle Inserts_v1 - Straight Holes
• Jeep Handle Inserts_v2 - Beveled Holes
• Jeep Handle Inserts_v3 - Slotted Holes

PRINT SETTINGS:

• 0.2mm Layer Height
• 5% Infill
• Printed Face down on textured bed.