Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
48 min
1 plate
Boost
9
21
6
0
26
9
Released
Description
This chameleon/iguana-shaped paper clip is just 4cm long yet it can hold a lot of paper sheets, even more than 2cm of height.
It will be a cute companion on your desk, and bite your fingers from time to time :)
Comment & Rating (6)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
A nice and practical design! Thank you! A tip for those who are going to print is that with PLA, the material loses its resilience, causing it to stay open. In that case, I would recommend PETG or ABS instead.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Strength Issue:doesnt work..
The designer has replied
0
Reply
You look a lot like a bot...
(Edited)1
Reply
except I’m not.. the ‘spring’ system doesn’t last. it’s cute, I will give you that
(Edited)1
Reply
Replying to @user_3373783013
pla or petg?
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed perfectly As-Is based on the designer profile. Works in PLA but can loose it's "springiness" - works a lot better in PLA+ or ABS.
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld