Canon EF/EFS Lens Cap for Reflex Lens
Copyright Claim
Canon EF/EFS Lens Cap for Reflex Lens
Boost
5
15
10
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.2 h
1 plate
Boost
5
15
10
2
50
36
Released
Comment & Rating (10)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Print came out perfectly and the ironing on the top of the logo was a nice touch.
The only reason it wasn't 5 stars is it only seemed to fit a couple of my EF lenses, and on both of those it was extremely tight, to the point I wasn't sure if I was going to be able to remove it for a moment.
I can't figure out what was blocking me from fitting it to my other EF lenses
The designer has replied
0
Reply
Which lenses in particular?
0
Reply
PLA shrinks a tiny amount depending on the brand and conditions, resizing to 100.2% may work better for you.
0
Reply
Replying to @user_1390842284
Thanks, yeah I understand that completely. However this was severely tight, and a brand new, good wualiry, dehydrated filament shouldn't shrink so much it prevents usage. If it does, better tolerance should be allowed in the design if being distributed for mass use.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Worked beautifully
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld