Chicken Peep by 3DMDesign

3DMDesign

Art>Sculptures

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

[Multi Color Print] 0.2mm layer, 3 walls, 10% infill

Designer

16.3 h

1 plate

4.6(19)

Open in Bambu Studio

Boost

208

288

475

235

Released

Description

Meet Peep, the charming baby chick with oversized eyes that sparkle with curiosity, perfect for brightening up any room. This 3D printable companion promises a simple print, ensuring an adorable result that's both playful and heartwarming.

Comment & Rating (34)

@garrettalansmit

Print Profile

[Multi Color Print] 0.2mm layer, 3 walls, 10% infill

(Edited)

Other Issues:overhang under the head is too agressive, especially in the chin area, for a profile with no support underneath.

The designer has replied

@3DMDesign

I'm disappointed you're rating the model with two stars. But next time try to adjust the temperatures or your printer. Other printers' overhangs don't look as bad as yours.

@garrettalansmit

Replying to @3DMDesign :

I'm disappointed that all of these are failed prints in my opinion. I used your profile, so I rated it. Simple as that. If I had used my profile there wouldn't be anything to rate. Take it constructively, tune your uploaded print profile.

@3DMDesign

Replying to @garrettalansmit :

I still think the problem is more likely with your out-of-tune printer. Other users just don't have this bad overhang even when they use my profile.

@ElizabethClark

Print Profile

[Multi Color Print] 0.2mm layer, 3 walls, 10% infill

Printed no problems. The only downside was this needed to have been 5 colors, not just 4. Wasn’t able to make the top of the chick red, but it’s still cute.

The designer has replied

@3DMDesign

Glad you like this model :)

@Ccarestia

Print Profile

[Multi Color Print] 0.2mm layer, 3 walls, 10% infill

Printed as a gift for a coworker in exchange for farm fresh eggs. She adores it!

The designer has replied

@3DMDesign

😍

@GyroGearl00se

Boosted

Print Profile

[Multi Color Print] 0.2mm layer, 3 walls, 10% infill

I placed a negativ disc pretty close to the bottom where I placed a RFID tag inside it while printing (paused at layer). This will be used for a Tonuino representing the Kids Song "Chick Chick Chick Chick Chicken (Lay a Little Egg for Me)". Just made the eyes a little bit smaller :) The print looks overall pretty good. Thank you :)