Gridfinity Caliper Holder

Remixed by
Copyright Claim

Gridfinity Caliper Holder

Remixed by
Boost
21
50
15

Print Profile(2)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

0.2mm layer, 3 walls, 15% infill
0.2mm layer, 3 walls, 15% infill
1.7 h
1 plate
4.7(13)

0.28mm layer, 2 walls, 25% infill
0.28mm layer, 2 walls, 25% infill
1.3 h
1 plate
5.0(1)

Open in Bambu Studio
Boost
21
50
15
0
97
84
Released

Description

Works with these calipers, however, many others should also fit :)

Comment & Rating (15)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 3 walls, 15% infill
works great!! added to my desk workshop area!
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Ich musste Suporrt rr Hinzufügen Weil er bei den Löchern auf der r Unterseite mid Air anfängt zu drucken. Infill kann problemlos auf 8% reduziert werden. 2 Wandschichten reichen.
(Edited)
0
Reply
Nice remix! works with the cheap plastic calipers. I like how I can put some sharpies in the base too. Thanks!
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
The model is super nice and printed well on my A1 with PLA Basic
Other Issues:But even if I have the same caliper model, it’s too tight and doesn’t fit nicely
0
Reply
Print Profile
0.28mm layer, 2 walls, 25% infill
Print works well. Holder fits most flush cutters i have.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply