Listed below are some changes that were made.
- Switched to use M3x25mm screws, nuts, and optional washers.
- Moved the Flipper Zero to the bottom of the case and moved the devboard compartment to the top.
- Added Flipper Zero text & logo to the top of the model.
- Created a dual devboard holder.
- Enlarged the compartment for storing various other boards.
- Added a shim for the case. Allows for the Flipper to fit without needing a silicone case.
Requirements:
- 4x M3x25mm screws (nuts & washers are optional it will vary on your printer's tolerances)
- ¼ inch foam if you want to keep everything snug, although it is not required.
This model was a remix of:
Revisions
- V1_1 (Updated hinge file to fit the screws)
- V1_2 (Added a shim to allow for the Flipper to fit if you don't have a silicone case)
Credits
Lily _@_v for the redesign
@Zardoz for file organization & presliced .3mf files.
@zR_CrackiiN for creating the spacing shim file.