This is a wall-mounted foldable clothes hanger. Each segment is 190mm long. It is print in place. It is designed for a layer height of 0.2mm.

Each segment snaps in place when unfolded completely to avoid undesired movement while there is clothes on it. It can be snap out of place and folded when not in use.

Even if the hanger is quite sturdy, it is highly recommended to add a rope to support the last segment and prevent it from breaking or bending over time. I included a printable simple hook if you dont have one. Add a rope to support from the wall or the ceiling

Note: It is designed for a layer height of 0.2mm

Print settings

Infill: 45%

Layer height: 0.2mm

Material: PLA

Supports: No