Swatch Display Board Holder
Copyright Claim
Swatch Display Board Holder
Boost
106
234
13
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
7.9 h
1 plate
Boost
106
234
13
1
391
78
Released
Description
Swatch Display Board by Bambu Lab Holder for 8 Boards
Comment & Rating (13)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
End product turned out great. Support trimming does take some time but worth it.
2
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The hybrid tree supports did take around an hour to weed. Overall, nice design.
2
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
These are great
(Edited)1
Reply
One of the first prints I ever tried. The support material was, abundant, so it took a while to get it all removed. Now that I know a little bit more about printing, I may try this again with modified support settings to make removing the supports easier. It also warped a bit at the bottom when printed on my A1 using PTEG, so I'd suggest a brim to help with that.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Great way to store swatch plates. My only issue was some of the supports it printed for printing stabilization were difficult to get off.
0
Reply
nice design
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Support Issue
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Public Domain
© 2024 MakerWorld