Side spool mount with AMS Hub mount by Pretzel 3D

Pretzel 3D

3D Printer>3D Printer Accessories

Print Profile(1)

All

P1P

P1S

X1 Carbon

X1E

0.2mm layer, 5 walls, 15% infill

Designer

2.8 h

1 plate

5.0(4)

Boost

Released

Description

I designed this side spool mount with AMS hub so i could have my AMS units hung on the wall to the left of my printer.

I use heat inserts on the rear to hold the stock spool holder (i use someone else'd print for the roller - thrutheframe) strong to the mount and then connect to the stock spool mounting points on the printer. The AMS is just screwed into the print with nothing extra needed.

I also forgot to mention this was designed for the arc enclosure, hence why there is a notch where it screws into the existing spool holder location, if needed i can tinker a flat version for those with P1S or the flat back plate.

Comment & Rating (5)

@AddManu

Print Profile

0.2mm layer, 5 walls, 15% infill

printed great, really recommend it for keeping your setup clean with an AMS on the left side.

The designer has replied

@Pretzel3D

thanks I couldn’t find something so tinkered this, also have one for the basic buffer I was using when I only had one and. did you get on all right with the heat set inserts? as I had to clean out the channel when I did it to get the screws to go through nicely else it would try and push them out