40mm Door Hook Remixed by anonim1133

Remixed by

anonim1133

Household>Other House Models

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 16% gyroid infill, concentric bottom/face pattern

Designer

34 min

1 plate

5.0(2)

Open in Bambu Studio

Boost

Released

Description

I've needed something to hang some clothes somewhere… So I've found that hook on Makerworld and made it fit my door (40mm)

The original author feared its rigidity, so I've reinforced it just in case. But the original model seemed to hold clothes with no issue.

I've printed it using 2 wall loops with a concentric bottom/face pattern using 16% gyroid infill.

door hook

Comment & Rating (8)

@landubious

Print Profile

0.2mm layer, 2 walls, 16% gyroid infill, concentric bottom/face pattern

Printed great in clear PETG. Unfortunately it broke when my son accidentally closed the door too hard.

The designer has replied

@anonim1133

MInd showing picture of broken one?

@landubious

Replying to @anonim1133 :

Here ya go. I had printed another one and had it on the opposite side of the door. That one survived the abuse. A comment on the model is that it is just a little big on my door, but knew that going in.

@anonim1133

Replying to @landubious :

You could try to add more walls and infill. But probably kids will find a way to destroy it eitherway :D If your door are thinner than mine 40mm I can adapt it quite easily if you will pass me door width.