Hello Kitty Coaster
Remixed by
Hello Kitty Coaster
Remixed by
Boost
16
18
2
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
1.1 h
1 plate
Open in Bambu Studio
Boost
16
18
2
0
25
19
Released
Description
printed fine at .2 layer height 15% infill, i printed in petg and pla, petg because i had a nice pink that i wanted to try however the top did not come out nearly as nice as it did when i used pla
Comment & Rating (2)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
came out grade would like to see a version that was flat on the top so it will hold smaller cans without tilting the can.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld