Backwards revolver that will twist your mind.
Leave it as is or get creative with paint and make it more
This is not are real gun. It's a prop, a fake.
All parts are spread across 3 plates.
Plate 1: Left and Right frame section. I used minor supports on a few areas.
Plate 2: Left and Right Barrel. Minor supports used. Barrel pin L&R, Cylinder and cases and Lanyard L&R
Plate 3: Left and Right Grip, You may want to use a low layer height or adaptive layering for cleaner results
Print time about 6-ish hours for everything, assembly time maybe 1-2. It's gonna take a little use of those grey squishy bundled cells between your ears.
Parts are held together with pins made of filament and glue (make sure any pin holes are not blocked by supports, ask me how I found out)
Dry fit everything before gluing as well. You may need to file down where a support touched, or resize a hole.
All credit goes to Thorped for the design. I just tweaked a few things and made it a bit simpler to print.