Print Profile(1)
0.2mm layer, 2 walls, 15% infill
36 min
1 plate
Open in Bambu Studio
Boost
7
31
5
0
142
53
Released
Description
This is a case I designed for the ESP32 WROOM microcontroller. I printed this on a Mars 2 Mono.
Comment & Rating (5)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
The print profile is no longer public
Other Issues:case collapsed into a single solid piece on printout. unusable
0
Reply
The print profile is no longer public
Support Issue:I had some issues printing this one due to the raised buttons.
I ended up getting it printed though, a potential solution would be to have the buttons flat on top, with them extending further into the chasis to provide the raised feel.
Unfortunately this didn't fit my aliexpress esp32 wroom 32u, however, the model seems brilliant with access below for pin outs
0
Reply
The print profile is no longer public
0
Reply
The print profile is no longer public
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
© 2024 MakerWorld