MINI SABER collaspible/telescoping sword by Joe Wilson

Joe Wilson

Props & Cosplays>Other Props & Cosplays

GIF

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

A1 mini

MINI SABER *** 52 MINUTES *** 0.28mm layer, 2 walls, 10% infill

Designer

59 min

1 plate

4.6(101)

Same profile just for the A1 mini

1.1 h

1 plate

4.6(38)

Boost

239

351

165

1.1 k

1.5 k

Released

Description

MINI SABER

its a small saber/sword that telescopes out, easy to print

*** PRINTING ***

print upside down, blades facing bed

use support for the middle blade only

use brim

Comment & Rating (165)

@Karma.

Print Profile

MINI SABER *** 52 MINUTES *** 0.28mm layer, 2 walls, 10% infill

Used a nickel to get the last layer unstuck. Nickel fits perfectly 👌

(Edited)

@llcmhdesigns

im have to do that cause last layer got stuck on me two. maybe lower wall count i think it maybe a solution im reprint and see

@user_1192827391

Print Profile

Same profile just for the A1 mini

they got stuck

@westcott.accts

if they get stuck slam the stuck part into a table to get them unstuck

@user_1192827391

i did they broke

@user_2373038646

Replying to @user_1192827391 :

My case the inner tube did proke apart into two pieces

@Gaspertt16

Boosted

Print Profile

MINI SABER *** 52 MINUTES *** 0.28mm layer, 2 walls, 10% infill

great model printed one for my nephew. had to open bambu studio to print it on the a1 mini will upload the profile for people to be able to print it straight from the handy app

The designer has replied

@joewilson09

please can you add a picture to the print profile, otherwise it will get taken down

(Edited)

@Gaspertt16

Boosted

Replying to @joewilson09 :

yes i did

(Edited)

@Lunavixen

Print Profile

MINI SABER *** 52 MINUTES *** 0.28mm layer, 2 walls, 10% infill

Absolutely wonderful, even my mum can't stop playing with them, printed using the designers profile and other than an obvious external seam and the odd section sticking (fixed by pulling apart, pushing the offending segment from the other side and reassembling) it's been a treat to print

The designer has replied

@joewilson09

glad you like it thanks

(Edited)

@xpisoverrated

Print Profile

MINI SABER *** 52 MINUTES *** 0.28mm layer, 2 walls, 10% infill

Prints well with provided profile, used Bambu PLA Orange. Under 60 mins print time. Nice design, works straight off the bed.

(Edited)

@user_1499553184

Print Profile

MINI SABER *** 52 MINUTES *** 0.28mm layer, 2 walls, 10% infill

letzter und erster Teil fahren nicht aus und kleben aneinander. wenn man die Z Naht versetzt geht es. Gedruckt in Bambu Glow

@trpkelly91

Print Profile

MINI SABER *** 52 MINUTES *** 0.28mm layer, 2 walls, 10% infill

Printed pretty well for me, only issue I had was the largest and smallest sections got stuck. However, I was able to break them free and now works as intended