Magnetic Extended-ramp Poop Chute by mrdgelinas

mrdgelinas

3D Printer>3D Printer Parts

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

0.08mm layer, 3 walls, 15% infill

Designer

8.2 h

1 plate

4.7(9)

0.08mm layer, 3 walls, 15% infill

Designer

7 h

1 plate

4.8(5)

Open in Bambu Studio

Boost

117

Released

Description

I wanted a poop chute to dump poop directly into my trash bin. I had one with flexible tubes, but it kept getting clogged as the opening was just not wide enough. I couldn't find one that met my needs and stuck out beyond the sides of the x1, so I spent a few minutes designing my own. It's made to stick out about 55mm from the side of the x1, and is tall enough that it will only work if your x1 is on some sort of riser. If you need a chute for an x1 that has not been raised, used the shortened version which has just been added as of 2/1.

The chute is mounted using ten 8x3 magnets.

Comment & Rating (22)

@Hoddl666

Print Profile

0.08mm layer, 3 walls, 15% infill

super vielen dank für das Model... passt super!!! Druck war auch einfach

@Miguel_Calero

Print Profile

0.08mm layer, 3 walls, 15% infill

Diseño aceptable, cumple su función.

@BAUD9600

Hi. Are you willing to shorten it to match normal X1 height?

The designer has replied

@mrdgelinas

sure!

@BAUD9600

Replying to @mrdgelinas :

Thank you! I look forward to printing it when it's ready.

@mrdgelinas

Replying to @BAUD9600 :

Should be up Joe, give it a try. There's a second print profile for it as well.

@Networkloop

Print Profile

0.08mm layer, 3 walls, 15% infill

@3DPRNT4LF

Print Profile

0.08mm layer, 3 walls, 15% infill

best poop chute so far!

@user_1599109376

Hi, I designed a purge collection design for recycling that reuses the filament plastic bag. I only own an A1 Mini but think with a chute it would also perfectly fit next to the x1. Could you maybe test if it works together with your design? I could add a link to your design then.

@TheWrongGuy

Print Profile

0.08mm layer, 3 walls, 15% infill

It printed great but it was slow I am going to have to look at the settings because I need to print more. I can only compare it to others I have printed. probably something I did

@AnjelaB

Print Profile

0.08mm layer, 3 walls, 15% infill

Printed great and works awesome.

@Mr.Markley

can i get a remix to extend the end slightly and angle the end 45 degrees towards the front of the printer. I have a large picture frame that sticks out quite a bit and need to angle it away from that. Thank you if you can!