Dollar Coin Tube
Copyright Claim
Dollar Coin Tube
Boost
2
7
3
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
54 min
1 plate
Simple Case 0.2mm layer, 2 walls, 15% infill
Designer
44 min
1 plate
Open in Bambu Studio
Boost
2
7
3
1
11
13
Released
Description
A coin tube to hold 25 dollar coins. There are two models, one with simple sides, and one with some cutouts to give it some style.
Comment & Rating (3)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Nice Design, but I did have to sand down the inside of the lid and the outer lip of the tube to actually make the top work. The first time I printed this I did not sand it and I struggled to get the top on... then I couldn't get it off. Litterally had to get two pairs of pliers to pull the two ends apart. A little 220 grit sand paper and the tubes work great. Perhaps it was the type of PLA I was using, but its something you need to know about the design. I only printed the decorative one.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
fits great! i also printed one to hold my maker coins so i had to scale it up a bit.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld