The “Little Boy Brew” is a cool little pocket launcher that uses a two part projectile consisting of a casing and bullet! Can shoot over 20 feet with a little bit of an upwards angle. This is quite powerful at close range so you appropriate caution when firing.
Simple to print and build! Only requires a few extra pieces' of easy to find hardware. Please enjoy safely!
Print Settings:
Material: PLA, PLA+, PETG
Walls/Top/Bottom: 4+
Infill: 15% or more.
Supports: Only required for the frame (Regular supports recommended)
Hardware:
3 x M3*15 Bolts
2 x M3*10 Bolts
1 x M3*20 Bolt
3 x M3 Nuts
1 x Pen Spring (Cut in half - One half for barrel latch, other half for the striker latch.
1 x Striker Spring - OD: 9.5 mm, ID: 8mm, WD: 0.8, Free Length: 46mm