I have a P1P with the EasyARC enclosure, and I wanted a place to fit my twin set of Anycubic Air Purifiers to reduce the VOC levels while printing ABS/ASA, so I designed this raiser to allow fitting the air purifiers on top (for maximum extraction), while still maintaining the printer's good looks, and avoiding high angles of the PTFE which could cause extrusion problems.

This was made to work seaminglessly (locking tabs) with the EasyARC enclosure, but the dimensions will work also with any squared shaped P1P enclosure.

This will make the top glass sit 62mm above the original place, which should also solve a lot of the PTFE tube angle problems that some people are having (With the top glass, the PTFE gets a too hard angle, creating extrusion problems).

Provided is the .3MF project files. Additionally you should also print the locking tabs (to lock the pieces together) and use a M3 screw and M3 brass inserts. It uses the same dimensions brass inserts and screws than ARC project.

INFO: CAN BE PRINTED WITHOUT SUPPORTS!